Baker Manufacturing Company - STANDARD INDUSTRIAL PITLESS UNITS

PRINT THIS PAGE

BACK TO HOME

6” I.D. STANDARD INDUSTRIAL SPECIFICATION

Ordering Information

Industrial Specifications

Parts Breakdown

A	Screened Well Vent tap size:	1-1/2” NPT
B	Seal Cap: The Watertight cap bolts to a compression seal ring securing around the pitless case and comes with the screened well vent installed.
C	Conduit Tapping size: Watertight conduit seals for most common cable sizes are available for watertight cap.	1-1/2” NPT
D	Depth Tester Tapping:	1/4” NPT
E	Distance from ground level to top of Pitless Case:	12”
G	Distance from ground level to top of Screened Well Vent:	19-1/2”
H	Pitless Case I.D. size:	7”
I	Pitless Case wall thickness:	.300”
J	“Hold-Down” - “Lift-Out” Mechanism Three set screws in a spider atop the “Hold-Down” - “Lift-Out” pipe brace against the interior of the pitless casing, locking the spool in place. Hold-Down, Lift-Out pipe size (Schedule 80): Designed “Lift-Out” Mechanism load:	2” NPT 15,000 lbs.
	DISCHARGE BODY - THREADED
K	Discharge Body outside diameter:	9-11/16”
K	Discharge Body length: DISCHARGE BODY - KWIKONECT	11-1/4”
K	Discharge Body outside diameter:	10”
K	Discharge Body length:	12-9/32”
L	Pitless Unit minimum inside diameter.:	6-3/8”
M	Discharge Connection Tapping size:	3” NPT
N	Pitless Unit to well casing connection I.D.:	6” Weld
O	SPOOL ASSEMBLY Spool Design Load:	15,000 lbs.
P	MOTOR CABLE PASSAGES THROUGH SPOOL	13/16”
Q		1-3/4”
R	Spool to Drop Pipe Connection:	3” NPT
S	Pressure zone tapping: 3/8” NPT:	(2) available
T	Dimension from center of discharge outlet to bottom of weld nipple:	9-3/8”
U	Overall length of seal cap:	12-7/8”
V	Dimension from center of discharge to bottom of discharge body:	7-3/4”
W	Dimension from center of well casing to end of discharge outlet:	5-25/32”

Specifications are Subject to Change Without Notice.

For Flowing Well spool concept, see Booster Station section.

*Optional flange, weld or mechanical joint available upon request.

Note: Pitless units conform to the Recommended Standards for Water works, Great Lakes Upper Mississippi River Board of State Public Health & Environmental Managers and Water Systems Council PAS-97 (04) Standards.

COMPONENT MATERIALS

Well Vent - cast iron, green enamel finish.
Cap & Conduit Box - cast iron, green enamel finish.
Hold-Down Spider - cast iron, green enamel finish.
Hold-Down Pipe, 2” - steel Sch. 80, black.
Pitless Case - steel, black.
Spool - cast iron, lead-free galvanized.
Discharge Body - cast iron, lead-free galvanized.
Check Valve Body & Arms - brass.
Check Valve Seat - Brass.
Check Valve Spring - Monel.
Compression Seal Ring & Check Valve Facing - Neoprene.
Electrical Conduit Cable Seal - Neoprene.
Maximum Rated Discharge Pressure - 300PSI