| A |
Screened Well Vent tap size: |
1-1/2” NPT |
| B |
Seal Cap: The Watertight cap bolts to a compression seal ring securing around the pitless case and comes with the screened well vent installed. |
|
| C |
Conduit Tapping size:
Watertight conduit seals for most common cable sizes are available for watertight cap. |
1-1/2” NPT |
| D |
Depth Tester Tapping: |
1/4” NPT |
| E |
Distance from ground level to top of Pitless Case: |
12” |
| G |
Distance from ground level to top of
Screened Well Vent: |
19-1/2” |
| H |
Pitless Case I.D. size: |
7” |
| I |
Pitless Case wall thickness: |
.300” |
| J |
“Hold-Down” - “Lift-Out” Mechanism
Three set screws in a spider atop the “Hold-Down” - “Lift-Out” pipe brace against the interior of the pitless casing, locking the spool in place.
Hold-Down, Lift-Out pipe size (Schedule 80):
Designed “Lift-Out” Mechanism load:
DISCHARGE BODY - THREADED |
2” NPT
15,000 lbs. |
| K |
Discharge Body outside diameter: |
9-11/16” |
| K |
Discharge Body length: |
11-1/4” |
| L |
Pitless Unit minimum inside diameter.: |
6-3/8” |
| M |
Discharge Connection Tapping size: |
3” NPT |
| N |
Pitless Unit to well casing connection I.D.: |
6.6” Weld |
| O |
SPOOL ASSEMBLY
Spool Design Load: |
15,000 lbs. |
| P |
MOTOR CABLE PASSAGES THROUGH SPOOL |
13/16” |
| Q |
|
1-3/4” |
| R |
Spool to Drop Pipe Connection: |
3” NPT |
| S |
Pressure zone tapping: 3/8” NPT: |
(2) available |
| T |
Dimension from center of discharge outlet
to bottom of weld nipple: |
9-3/8” |
| U |
Overall length of seal cap: |
12-7/8” |
| V |
Dimension from center of discharge to
bottom of discharge body: |
7-3/4” |
| W |
Dimension from center of well casing to
end of discharge outlet: |
5-25/32” |
|
Specifications are Subject to Change Without Notice. | 
6" Industrial Pitless
